Certification Conformity

FCC and ISED Certification

Component Manufacturer Model Operating Frequency (MHz) FCC ID IC ID
B-Pillar Endpoint Tesla 1783148Y

13.56

2400-2483.5

2AEIM-1783148Y 20098-1783148Y
Center Console Tesla 1089774

13.56

2400-2483.5

2AEIM-1089774

20098-1089774

Rear Endpoint

Tesla

1509516

2400-2483.5

2AEIM-1509516

20098-1509516

Key fob Tesla 1133148 2400-2483.5 2AEIM-1133148 20098-1133148
TPMS

Tesla

1472547G

2400-2483.5

2AEIM-1472547G

20098-1472547G

In-Cabin Radar* (if equipped) Tesla 1616631 60000-64000 2AEIM-1616631 20098-1616631
Homelink (if equipped) Gentex ADHL5C 286-440MHz NZLADHL5C 4112A-ADHL5C
Car PC Tesla

1960400

XMR2020AG525RGL XMR202201AF51Y 10224A-2020AG525R 10224A-202201AF51Y
Wireless Charger Tesla

WC3

127.72KHz

2AEIM-WC3

20098-WC3

*In-cabin radar is restricted to factory installation.

The devices listed above comply with Part 15 of the FCC rules and Industry Canada's license-exempt RSS Standard(s) and EU Directive 2014/53/EU.

Operation is subject to the following two conditions:
  1. This device may not cause harmful interference; and
  2. This device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by Tesla could void your authority to operate the equipment.

Radio Frequency Information

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, try to correct the interference by one or more of the following measures:
  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician to help.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
This equipment and its antennas must not be co-located or operated with another antenna or transmitter.

Radiation Exposure Statement

The products comply with the FCC/ISED RF Exposure for Low Power Consumer Wireless Power Transfer. RF exposure limits are set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The farthest RF exposure demonstrated by compliance was at 20cm and farther from the user's body; set the device to low output power if such function is available.

Singapore

Image of example of compliance label.