Wipers and Washers

Wipers

The button at the end of turn signal stalk has two levels. Press partially for a single wipe without any washer fluid. Press fully for both wipe and wash. You can access the wiper settings from the main Controls screen to adjust the speed of the wipers:

I - Intermittent, slow

II - Intermittent, fast

III - Continuous, slow

IIII - Continuous, fast

Auto: Model Y detects whether or not it is raining. When wipers are set to Auto and liquid is detected on the windshield, Model Y determines the optimal frequency at which they should wipe. If Model Y does not detect liquid on the windshield, the wipers do not wipe.

For one-touch access to the wipers, you can add the wiper control to My Apps. See Customizing My Apps.

Informational PurposesAn informational icon, calling your attention
Note
You can also adjust the windshield wiper speed and frequency using voice commands (see Voice Commands).
Informational PurposesAn informational icon, calling your attention
Note
Autopilot requires wipers to be set to Auto. This setting is automatic and you cannot change it.
Informational PurposesAn informational icon, calling your attention
Note
The Auto setting is currently in BETA. If uncertain about using the Auto setting while in the BETA phase, Tesla recommends operating the wipers manually, as necessary.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Ensure the wipers are off before washing Model Y to avoid the risk of damaging the wipers.

Periodically check and clean the edge of the wiper blades. If a blade is damaged, replace it immediately. For details on checking and replacing wiper blades, see Wiper Blades and Washer Jets.

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
To avoid damaging the hood, ensure that the hood is fully closed before using the windshield wipers.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
In harsh climates, ensure that the wiper blades are not frozen or adhered to the windshield. Remove ice from the windshield before using the wipers. Ice has sharp edges that can damage the rubber on the blades.

Windshield Washers

Press the button on the end of the turn signal stalk to spray washer fluid onto the windshield. This button has two levels. Press partially for a single wipe without any washer fluid. Press fully for both wipe and wash. When washing the windshield, the wipers turn on. While spraying the windshield, the wipers turn on. After releasing the button, the wipers perform two additional wipes then, depending on vehicle and environmental conditions, a third wipe a few seconds later.

Turn signal with arrow pointing to tip

Periodically top up washer fluid (see Topping Up Windshield Washer Fluid).