To open the front trunk, ensure Model 3 is in Park, and then do one of the following before pulling the hood open:
- Touch the associated Open icon on the touchscreen.
- Touch the front trunk button in the mobile app.
The Model 3 hood is not heavy enough to latch under its own weight and applying pressure on the front edge or center of the hood can cause damage.
To properly close the hood:
- Lower the hood until the striker touches the latches.
- Place both hands on the front of the hood in the areas shown (in green), then press down firmly to engage the latches.
- Carefully try to lift the front edge of the hood to ensure that it is fully closed.
- Apply pressure only to the green areas shown. Applying pressure to the red areas can cause damage.
- Do not close the hood with one hand. Doing so applies concentrated force in one area and can result in a dent or crease.
- Do not apply pressure to the front edge of the hood. Doing so can crease the edge.
- Do not slam or drop the hood.
- To avoid scratches, don't have anything in your hands (keys). Jewelry can also cause scratches.
If the front trunk is left open when you attempt to shift out of Park, a notification requiring you to confirm your intent to drive appears on the touchscreen. If you choose to keep the front trunk open while driving, your vehicle speed is limited.
Front Trunk Load Limit
Distribute the weight of cargo as evenly as possible between the front and rear trunks.
Interior Emergency Release
An illuminated interior release button inside the front trunk allows a person locked inside to get out.
Press the interior release button to unlatch the front trunk, then push up on the hood.
Opening Hood with No Power
In the unlikely event that Model 3 has no low voltage power, you will be unable to open the front trunk using the touchscreen or mobile app. To open the front trunk in this situation:
- Locate an external low voltage power supply (such as a portable jump starter).
- Release the tow eye cover by pressing firmly on the top right perimeter of the cover until it pivots inward, then gently pulling the raised section toward you. NoteThe tow eye cover is connected to the vehicle's black negative (-) terminal.NoteYour vehicle may also have a tow eye cover near the rear bumper. That is used for transporting only, and does not contain the proper wires for jump starting. Only use the front tow eye cover.
- Pull the two wires out of the tow eye opening to expose both terminals.
- Connect the low voltage power supply's red positive (+) cable to the red positive (+) terminal.
- Connect the low
voltage power supply's black negative (-) cable to the black negative (-) terminal.NoteApplying external low voltage power to these terminals only releases the hood latches. You cannot charge the low voltage battery using these terminals.
- Turn on the external power supply (refer to the manufacturer’s instructions). The hood latches are immediately released and you can now open the hood to access the front trunk area.
- Disconnect both cables, beginning with the black negative (-) cable.
- If pulling the vehicle onto a flatbed truck, do not replace the tow eye cover yet. If necessary, install the tow eye cover by inserting the wires into the tow eye opening and aligning the tow eye cover into position and snapping it into place.