Certification Conformity

FCC and ISED Certification

Component Manufacturer Model Operating Frequency (MHz) FCC ID IC ID
B-Pillar endpoint Tesla 1783148 13.56, 2400-2483.5, 6000-8500 2AEIM-1783148 20098-1783148
Interior endpoint Tesla 1815669 2400-2483.5, 6000-8500 2AEIM-1815669 20098-1815669
Rear left BLE Tesla 1817073 2400-2483.5, 6000-8500 2AEIM-1817073 20098-1817073
Vivaldi Endpoint Tesla 1752108 2400-2483.5, 6000-8500 2AEIM-1752108 20098-1752108
Fascia endpoint Tesla 1733130 2400-2483.5, 6000-8500 2AEIM-1733130 20098-1733130
TPMS Tesla 1472547G 2400-2483.5 2AEIM-1472547G 20098-1472547G
TPMS Tesla 1849171 2400-2483.5 2AEIM-1849171 20098-1849171
Glove Box BT USB Module Tesla 1776863 2400-2483.5 2AEIM-1776863 2AEIM-1776863
In-cabin radar (if equipped)* Tesla 1616631 60000-64000 2AEIM-1616631 20098-1616631
Homelink (if equipped) Gentex ADHL5C 286-440MHz NZLADHL5C 4112A-ADHL5C
TCU Tesla 1727111 -- XMR2020AG525RGL XMR202303AF51Y 10224A-2020AG525R 10224A-202201AF51Y
Wireless phone charger Tesla WC5 13.56 MHz, 127.72 KHz 2AEIM-WC5 20098-WC5

* The in-cabin radar is restricted to factory installation.

The devices listed above comply with Part 15 of the FCC rules and Industry Canada's license-exempt RSS Standard(s) and EU Directive 2014/53/EU.

Operation is subject to the following two conditions:
  1. This device may not cause harmful interference; and
  2. This device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by Tesla could void your authority to operate the equipment.

Radio Frequency Information

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician to help.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
This equipment and its antennas must not be co-located or operated with another antenna or transmitter.

Radiation Exposure Statement

The products comply with the FCC/ISED RF Exposure for Low Power Consumer Wireless Power Transfer. RF exposure limits are set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The farthest RF exposure demonstrated by compliance was at 20cm and farther from the user's body; set the device to low output power if such function is available.

Device Approval - Australia, New Zealand

Image of example of label.